This PR changes the following to speed up L0 compaction and
prevent OOM:
1. Lower deltabuf limit to 16MB by default, so that each L0 segment
would be 4X smaller than before.
2. Add BatchProcess, use it if memory is sufficient
3. Iterator will Deserialize when called HasNext to avoid massive memory
peek
4. Add tracing in spiltDelta
See also: #30191
---------
Signed-off-by: yangxuan <xuan.yang@zilliz.com>
syncMgr.Block() will lock the segment when executing compaction.
Previous implementation was unable to Unblock thoese segments when
compaction failed. If next compaction of the same segments arrives,
it'll stuck forever and block all later compation tasks.
This PR makes sure compaction executor would Unblock these segments
after a failure compaction.
Apart form that, this PR also refines some logs and clean some codes of
compaction, compactor:
1. Log segment count instead of segmentIDs to avoid logging too many
segments
2. Flush RPC returns L1 segments only, skip L0 and L2
3. CompactionType is checked in `Compaction`, no need to check again
inside compactor
4. Use ligter method to replace `getSegmentMeta`
5. Log information for L0 compaction when encounters an error
See also: #30213
---------
Signed-off-by: yangxuan <xuan.yang@zilliz.com>
See also #27606
Previously l0 linear compaction will scan all target segment id from
metacache for each line of delta entry, which is not needed since
compaction target segments shall be all immutable.
Signed-off-by: Congqi Xia <congqi.xia@zilliz.com>
